With the continuous development of the times, the technology is increasingly sophisticated, more energy-saving environmentally friendly non-burning brick machine more and more customers love. In general, slag burned brick equipment prone to damage is the chain, tripod, sliding sleeve, there is the spring, these are wearing parts, the price is cheap, so save as much as possible, in the event of failure Time, direct replacement, replacement time to pay attention to several issues.
1, The replacement of the chain, about the length of the two chains to ensure the same, the only way to ensure that when the slag-free burners to enhance the balance of the mold raised to avoid one side of the high side of the phenomenon of low, thus increasing Burning brick molding rate,
2, Tripod replacement, this must be clearly the left of the tripod, or the right, because the direction is not the same, it can not be loaded, according to the original screw fastening on the line.
3, Slip sleeve, if there is a problem slip sleeve, it is necessary to replace a set of 16 pairs, this is too much trouble, the whole demolition of the brick should be almost the same, pay attention to the positive and negative sequence of sliding sleeve.
4, Spring, spring replacement, to choose the same height of the spring, so as to ensure the slag-free brick mold balance.
With the correct method to improve the repair time of slag-free brick equipment allows you to double the efficiency. Slag-free brick-making equipment will inevitably be damaged, more or less will have some impact on the production, so improve the time to repair the slag-free brick equipment can save some damage, but to speed up the maintenance time, but also to ensure The quality of maintenance.
